Table of Contents
Advertisement
Maintenance
Camera Alignment and Calibration
Scanner calibration is very easy to perform. Calibration is carried out using the WIDEsystem program you installed with your drivers. After manually cleaning the
scan area, you just start the Calibration wizard and let it take over. The wizard will ask you to insert a calibration sheet. Other than that, scanner calibration is
completely automatic.
NOTE: Cleaning and calibration depend on each other. A calibration made with a dirty scanner will affect the output until a new calibration is made even if
the dirt has been physically removed.
CLEANING THE SCANNER MUST ALWAYS BE FOLLOWED BY A NEW CALIBRATION
CALIBRATION NEEDS THE SCANNER TO BE CLEAN
Calibration
32
Turn the scanner power ON
There is no need to make sure that the scanner has been ON for at least 5
minutes before carrying out camera alignment and calibration.
45
Advertisement
Table of Contents
