Programming - Henny Penny PFE-592 Operator's Manual

3-15.

PROGRAMMING

July 2003
1.
Press and hold the FUNCTION button for two seconds. "REG
PROGRAM" shows in the display, followed by "CODE".
2.
Press the code 1,2,3. "SELECT PRODUCT" scrolls across the
display.
If no buttons are pressed, within approximately
1 minute while in the Program Mode, the
controls will revert back to the Cook Mode.
3.
Press the appropriate product button, (1-0), to identify what product
you want to program.
4.
"INT1" and "TIME" flashes on the left side of the display. The right
side shows the starting time of the Cook Cycle and can be changed
by pressing the appropriate numbers. Ex: Press 1,0,0,0 and 10:00
flashes on the right side of the display, setting the start time at 10
minutes.
5.
After the time is set, press and release the FUNCTION button and
"INT1" and "TEMP" flashes on the left side of the display. The right
side shows the starting temperature and can be changed by pressing
the appropriate numbers. Ex: Press 2,5,0 and "250° F" will show
on the right side of the display, setting the start temperature at 250°
Fahrenheit.
6.
After the temperature is set, press and release the FUNCTION button
and "INTI" and "PRESS" flashes on the left side of the display. Press
any of the product buttons, (1-0), to turn the pressure on or off.
7.
After the pressure is set, press and release the FUNCTION button
and "INTI", "LOAD", and "COMP" flashes on the left side of the
display. The factory preset load compensation value shows in the
right side of the display.
35