Henny Penny PFE-592 Operator's Manual page 42

3-15.
PROGRAMMING
(CONT.)
April 2003
8.
After the load compensation, press and release the FUNCTION
button. "PROP" and "CONTROL" shows on the left side of the
display and the factory preset proportional control temperature shows
on the right side of the display.
9.
After the proportional control, press and release the FUNCTION
button. "ALM 1" and "TIME" flashes in the left side of the display,
and the first alarm time shows on the right side of the display. To
change the time the alarm sounds, press the appropriate product
buttons to set the time. Ex: Press 1,0,0,0. 10:00 flashes on the right
side of the display, which means when the timer counts down to 10
minutes, an alarm will sound.
10.
After alarm is set, press and release the FUNCTION button. "ALM
1", "SELF-'', and "CANCEL" flashes in the left side of the display
and "YES" or "NO" shows on the right side of the display. The yes
and no can be toggled by pressing any of the product buttons, (l -0).
"YES" means the alarm tone automatically stops after several beeps.
"NO" means someone must manually press the appropriate product
button to stop the alarm tone.
11.
Repeat steps 9 and 10 for alarms 2 and 3.
12.
After alarm 3 is set, press and release the FUNCTION button.
"FILTER" and "CYCLES" shows on the left side of the display and
the filter cycle value is on the right side of the display. The value is
the number of Cook Cycles that must completed before the control
signals the operator that the shortening needs filtered
36