Henny Penny PFE-592 Operator's Manual page 44

3-16.
SPECIAL PROGRAM
MODE (CONT.)
April 2003
Reset Usage
1.
Press and hold the FUNCTION button for two seconds until "REG
PROGRAM" shows in the display. As soon as "REG PROGRAM"
shows in the display, press and release the FUNCTION button 2
times until "RESET USE" shows in display.
2.
When "CODE" shows in the display, press 1-3-5. "DAILY" will
show in the display, and press any of the product buttons to reset
them to 0.
Factory Presets (F/C, Gas/Electric, Speaker Volume,
Speaker Frequency, Codes, Initialize System)
1.
Press and hold the FUNCTION button for two seconds until "REG
PROGRAM" shows in the display. As soon as "REG PROGRAM"
shows in the display, press and release the FUNCTION button 3
times until "FAC PRESET" shows in the display.
2.
When "CODE" shows on the display, enter 2-9-5-7. "DEG" and
"MODE" flashes in the display. Press any of the product buttons to
toggle from ºF to ºC, and vice versa.
3.
Press and release the FUNCTION button and "TYPE" and "FRYR"
flashes in the display. Press any of the product buttons to toggle from
"GAS" to "ELEC", or vice versa.
4.
Press and release the FUNCTION button twice, and "SPKR" and
"VOL" flashes in the display. The volume can be changed from 01 to
10, 10 being the loudest.
5.
Press and release the FUNCTION button 3 times, and "SPKR" and
"FREQ" flashes in the display. The frequency can be set from 100 to
2000.
6.
Press and release the FUNCTION button 10 times, and "INITIALIZE
SYSTEM" scrolls across the display. Press and hold any of the
product buttons and the display counts down from 5. Once the
display counts down, release the product button, and the control sets
factory preset parameters into the controls.
Before attempting to change the other modes in the
Factory Preset Mode, please call the Henny Penny
Technical Service Department at 1-800-417-8405,
38
or 1-937-456-8405.