To Raise Or Lower Platform Using Base Control Console; To Activate Platform Control Console - Skyjack SJ 7135 Operating Manual

Start Operation
3.8-2 To Raise or Lower Platform Using Base
Control Console
Be aware of overhead obstructions or
other possible hazards around the aerial
platform when lifting.
Do not lower the platform unless the
area below is clear of personnel and
obstructions.
1. Activate base control console (refer to
Section 3.8-1).
2. Select and hold enable switch.
3. Select and hold lower/neutral/raise switch to either
" " raise or "
to stop.
Page 48
WARNING
WARNING
" lower position. Release switch
3.8-3

To Activate Platform Control Console

1. Turn main power disconnect switch to " " on
position.
2. On engine control console, select off/on/start
switch to " " on position.
3. On base control console, pull out "
stop button.
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
4. Use the ladder of aerial platform to access
platform.
5. Close the gate.
6. On platform control console, insert key into off/lift/
drive key switch and select "
7. Pull out " " emergency stop button. A beeping
sound should be audible and light should come
on.
If beeping sound is not audible and light
does not come on, aerial platform must
be tagged and placed out of service.
8. Select low/high throttle switch to "
position.
Do not start the engine in the high throttle
position.
9. If diesel engine is cold, depress and hold glow
plug pushbutton for 15 to 20 seconds.
10. Depress and hold "
to start the engine.
Section 3 - Operation
" emergency
WARNING
" lift position.
WARNING
" low throttle
CAUTION
" engine start pushbutton
Mid Size & Full Size RTs
Engine Powered