Test Brake; Test Speed Limit - Skyjack SJ 7135 Operating Manual

Section 2 - Familiarization
Drive/Steer Enable
Trigger Switch
Torque Switch
Low/High Speed Range
Switch
Horn
Pushbutton
Glow Plug
Pushbutton

• Test Brake

Brake will engage instantly when
controller handle is released, causing
aerial platform to stop immediately.
1. Ensure path of intended motion is clear.
2. Activate and hold "
switch.
3. Drive aerial platform "
brake by releasing controller handle.
Result: Aerial platform should come to a
stop.
4. Drive aerial platform "
brake again by releasing "
trigger switch only.
Result: Aerial platform should come to an
instant and abrupt stop.
Mid Size & Full Size RTs
Engine Powered
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
Engine Start
Pushbutton
Lift Enable
Pushbutton
WARNING
" enable trigger
" forward. Test
" forward. Test
" enable
contained in this operating manual and on the aerial platform.
Rocker Switch
Drive/Steer
Controller
Low/High Throttle
Switch
Operation Light
Raise/Off/Lower
Switch
Off/Lift/Drive Key
Switch
Emergency Stop
Button

• Test Speed Limit

WARNING
Be aware of overhead obstructions
or other possible hazards around the
aerial platform when lifting.
1. Ensure path of intended motion is clear.
2. Select off/lift/drive key switch to "
position.
3. Raise the platform to an approximate
height of 4 meters.
4. Select off/lift/drive key switch to "
drive position and attempt to drive forward
or reverse.
Result: Aerial platform should move slower
than when it was in stowed position.
Function Tests
" lift
"
Page 29