Hydraulic/Electrical Compartment - Skyjack SJ 7135 Operating Manual

Section 2 - Familiarization
Typical Model 71xx shown
Electrical Panel
Main Power
Disconnect Switch
Load/Tilt
Sensor
Motion Control Manifold

2.3-6 Hydraulic/Electrical Compartment

-
Ensure all compartment latches are secure
and in proper working order.
• Main Power Disconnect Switch
-
Turn main power disconnect switch to
" " off position.
-
Ensure all cables are secure and switch
is in proper working condition.
• Base Control Switches
-
Ensure there are no signs of visible
damage and all switches are in their
neutral positions.
• Battery
Proper battery condition is essential to
good performance and operational safety.
Improper fluid levels or damaged cables and
connections can result in component damage
and hazardous conditions.
Explosion hazard. Keep flames
and sparks away. Do not smoke
near batteries.
Mid Size & Full Size RTs
Engine Powered
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
Cushion Cylinder
WARNING
contained in this operating manual and on the aerial platform.
Visual & Maintenance Inspection
Emergency Lowering
Access Rod
Main Manifold
Brake Manifold
WARNING
Battery acid is extremely corrosive -
Wear proper eye and facial protection as
well as appropriate protective clothing.
If contact occurs, immediately flush with
cold water and seek medical attention.
1. Check battery case for damage.
2. Clean battery terminals and cable ends
thoroughly with a terminal cleaning tool or
wire brush.
3. Ensure all battery connections are tight.
4. If applicable, check battery fluid level. If plates
are not covered by at least 13 mm of solution,
add distilled or demineralized water.
5. Replace battery if damaged or incapable of
holding a lasting charge.
WARNING
Use original or manufacturer-approved
parts and components for the aerial
platform.
Base Control
Switches
Page 17