Table of Contents
Advertisement
Section 3 - Operation
3.8-8 To Extend or Retract Manual Extension
Platform
1
2
Figure 3-8. Manual Extension Platform
1.
To extend/retract the manual extension platform,
remove the locking pin (item 1) then remove the
push bar locking pins (item 2) and rotate the push
bar towards the main platform. Extend the push
bar until it locks at full extension and push/pull the
extension platform using the push bar.
2.
Upon full extension or retraction, reinsert the
locking pin on the platform (item 1) to prevent
accidental movement of the manual extension
platform during travel or transport.
3.
When the push bar is not in use, pull the plungers
(item 3) on the push bar and retract it, then rotate
it back to its resting position and lock it into place
with the locking pins (item 2).
Mid Size & Full Size RTs
Engine Powered
3.8-9 To Extend or Retract Powered Extension
Platform (If Equipped)
1.
To extend the powered extension platform, ensure
3
"
" emergency stop button is pulled out.
2.
On platform control console, insert key into off/lift/
drive key switch and select "
3.
On the powered extension control console,
select and hold "
the extend/retract switch to the "
position. Release switch to stop.
4.
To retract platform, select and hold "
switch, then push extend/retract switch to "
retract position. Release switch to stop.
To protect against unintended movement of
the aerial platform, push in the emergency
stop button after you have arrived at your
desired location or elevation.
Start Operation
" lift position.
" enable switch, then push
" extend
" enable
WARNING
Page 51
"
- Quick Links:
- Electrical
Hide quick links:
Advertisement
Table of Contents
