To Steer; To Select Drive Torque - Skyjack SJ 7135 Operating Manual

Start Operation

3.8-6 To Steer

1. Activate platform control console (refer to
Section 3.8-3).
2. Select off/lift/drive key switch to "
position.
3. Activate and hold "
4. Press " " rocker on top of controller handle in
either direction to steer.
Steering is not proportional. Driving and
steering can be activated at the same
Page 50
" drive
" enable trigger switch.
NOTE
time.

3.8-7 To Select Drive Torque

1. High Torque: Select high torque when ascending
or descending grades, traveling on rough terrain
or when loading or unloading aerial platform. To
activate high torque, select low/high speed range
switch to " " low speed (high torque) position.
Aerial platform must be in fully retracted
position when operated on any grade.
Driving while elevated on any grade may
result in death or serious injury.
2. Low Torque: Select low torque when traveling on
a flat level surface. To activate low torque, select
low/high speed range switch to "
(low torque) position.
To protect against unintended movement of
the aerial platform, push in the emergency
stop button after you have arrived at your
desired location or elevation.
Section 3 - Operation
WARNING
" high speed
WARNING
Mid Size & Full Size RTs
Engine Powered