To Raise Or Lower Platform Using Platform Control Console; To Drive Forward Or Backward - Skyjack SJ 7135 Operating Manual

Section 3 - Operation
3.8-4 To Raise or Lower Platform Using
Platform Control Console
Be aware of overhead obstructions or
other possible hazards around the aerial
platform when lifting.
Do not lower the platform unless the
area below is clear of personnel and
obstructions.
1. Activate platform control console (refer to
Section 3.8-3).
2. Press and hold lift "
then select and hold raise/off/lower switch to
either " " raise or "
switch to stop.
To protect against unintended movement of
the aerial platform, push in the emergency
stop button after you have arrived at your
desired location or elevation.
If the tilt alarm sounds and the platform does
not, or only partially raises, immediately
lower the platform completely and ensure
that the aerial platform is on a firm level
surface.
Some models may be equipped with an
8-meter lift height restriction. To raise the
platform higher than 8 meters, the aerial
platform's outriggers must be properly
deployed before lifting from a fully lowered
position. Refer to
Mid Size & Full Size RTs
Engine Powered
WARNING
WARNING
" enable pushbutton,
" lower position. Release
WARNING
NOTE
NOTE
Section 3.8-10.
3.8-5

To Drive Forward or Backward

Be aware of blind spots when operating
the aerial platform.
Ensure that there are no personnel
or obstructions in the path of travel,
including blind spots.
1. Activate platform control console (refer to
Section 3.8-3).
2. On platform control console, select off/lift/drive
key switch to "
3. Activate and hold "
4. Push or pull controller handle forward or backward
to desired speed and direction of platform
travel.
5. Return controller to neutral center position to stop.
Release " " enable trigger switch.
To protect against unintended movement of
the aerial platform, push in the emergency
stop button after you have arrived at your
desired location or elevation.
Start Operation
WARNING
WARNING
" drive position.
" enable trigger switch.
WARNING
Page 49