Configuring Outputs With The Web App Interface - Barco ImagePRO-II Jr User Manual Addendum

5. Web Remote Control Operations
Figure 5-25. Area of Interest Page

To change the Area of Interest, use any of the following settings:
•
•
•
•
lÄí~áåáåÖ=lìíéìí=bafa=ïáíÜ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ
Extended Display Identification Data (EDID) is a data structure that an output display
uses to describe itself to a video source. The EDID can include information such as the
manufacturer's name, a serial number, product type, timings supported by the display,
display size, and other data.
For output devices connected to the ImagePRO-II, you can read the name of the digital
display and the preferred video format that the display uses.
The EDID Config page, shown in the following illustration, supports
device on the DVI-D, HD-15, HDMI, or DisplayPort connector change the output format of
the ImagePRO-II.
also change.
ImagePRO-II • User's Guide
H Size — Determines the width (in pixels) of the Area of Interest. This setting
must be equal to or less than the H Active setting of the output timing.
V Size — Determines the height (in lines) of the Area of Interest. This setting must
be equal to or less than the V Active setting of the output timing.
H Pos — If H Size is less than the H Active setting of the output timing, you can
move the image horizontally. The default setting of 0 represents the left of the
display, so increasing this value moves the Area of Interest to the right.
V Pos — After adjusting the V Size, you can move the image vertically within the
output's active vertical limits. The default setting of 0 represents the top of the
display, so increasing this value moves the Area of Interest down.
As the format changes, the colorspace, sample rate and bit depth may

Configuring Outputs with the Web App Interface

letting the output
153