Barco ImagePRO-II Jr User Manual Addendum page 83

4. Menu Orientation
Configuring Outputs
•
•
^Äçìí=dÉåäçÅâ=pÉííáåÖë
The Genlock Submenu tells the ImagePRO-II which signal to lock on, when you want to
synchronize to a source signal. The following illustration shows the options on the Genlock
Submenu.
GENLOCK
> Source
H/V Offset
Status
Figure 4-47. Genlock Submenu
The Genlock Submenu options are:
•
•
68
Figure 4-46. Image Flip — Vertical
The options are H, V, H+V, and Off. The default setting is Off.
Strobe Mode — This option turns the strobe effect
is Off. If Strobe Mode is on, the timing of the strobe's flash effect is determined by
the Strobe Rate setting.
Strobe Rate — This option sets the timing of the strobe's flash, when Strobe
Mode is on. The range of this rate is adjustable from
setting is 2 frames.
Source — This option selects the Genlock source from the following values:
Freerun, External, or an Input button. External sync supports both NTSC/PAL
blackburst and HD tri-level syncs.
H/V Offset — This option sets the Horizontal and Vertical offsets separately.
When you select this option, the Genlock Offset Submenu appears, and
provides the following options:
On or Off. The default setting
2 to 100 frames. The default
Freerun
>>
Freerun
ImagePRO-II • User's Guide