Dual Channel Mezzanine - Barco ImagePRO-II Jr User Manual Addendum

2. Hardware Orientation
ImagePRO-II Rear Panel
14) DisplayPort Output
15) SDI-2 Output
pPa=póåÅ=`çååÉÅíçêë
Conforming to the VESA 3D specification, these miniDIN 3-pin connectors are used to
indicate which eye corresponds to the current frame of single-stream 100/120 Hz video.
The output is always active when the output S3D format is Sequential and the input must
be connected whenever an S3D Sequential source is being processed through DVI or
HDMI. These connectors are on the 3D/Dual Channel mezzanine.
16) 3D Sync In
17) 3D Sync Out
dÉåäçÅâ=fåéìí=`çååÉÅíçê
18) Genlock Input BNC with passive Loop-through
^ìÇáç=jÉòò~åáåÉ
19) A user-installable option that supports the use of both embedded and external
PaLaì~ä=`Ü~ååÉä=jÉòò~åáåÉ
A user-installable option that supports processing stereoscopic 3D images and supports
the ImagePRO-II's dual-channel capability. This mezzanine includes the S3D sync
connectors, SDI Input 6 with loop-through, and a second SDI output.
14
The Genlock input supports NTSC and PAL Blackburst, as well as HD tri-level
sync signals, per SMPTE 274M and SMPTE 296M. The passive loop-through can
be used to pass the Genlock signal to another device downstream of the
ImagePRO-II and will continue to function when the ImagePRO-II is turned off.
When the ImagePRO-II is genlocked and the lock source is lost for some reason,
the output of the unit will automatically switch to "free-run" state without any
discernible "glitching" on the output display device.
audio.
ImagePRO-II • User's Guide