Barco ImagePRO-II Jr User Manual Addendum page 105

4. Menu Orientation
Using the System Menu
_~ÅâáåÖ=ré=içÖç=cáäÉë
After you capture and save a logo image, you can back it up to a flash drive. With the 3D/
Dual Channel mezzanine installed and the system mode set to Dual2K, you can back up
the image on either channel.

To back up a logo to a flash drive in standard system mode, use the following
procedure:
1.
2.
3.
4.
oÉëíçêáåÖ=içÖç=cáäÉë

To restore a logo file that is stored on a flash drive, use the following procedurein
standard system mode:
1.
2.
3.
90
A message confirms the restore operation and instructs you to reboot the
ImagePRO-II.
Note You must reboot the ImagePRO-II to use the restored
configuration file.
On the System Menu, select USB. The USB Backup/Restore Submenu
appears.
Select Backup Logo. The USB Backup Logo Submenu appears, as shown in
the following illustration. The navigation cursor is at the default logo filename.
USB BACKUP LOGO
> LogoBackup1
Backup Logo
(FAT filesystem only)
Figure 4-79. USB Backup Logo Submenu
If you wish to change the name of the backup logo, press SEL. Use the ADJUST
knob to change the name, as described in
Press SEL again when you complete the name change.
Scroll to Backup Logo and press SEL.
A message confirms the success of the backup operation.
For information about backing up a logo in dual-channel mode, refer to
Up a Logo in Dual-Channel
Insert the flash drive in the ImagePRO-II's front-panel USB port.
From the System Menu, select the USB Backup/Restore Submenu.
Select Restore Logo. The USB Restore Logo Submenu appears, as shown in
the following illustration.
USB RESTORE LOGO
> Logo1
Restore LOGO
(FAT filesystem only)
Figure 4-80. USB Restore Logo Submenu
Saving a Custom Format
Mode" on page 111.
ImagePRO-II • User's Guide
on page 75.
"Backing