Barco ImagePRO-II Jr User Manual Addendum page 75

4. Menu Orientation
Configuring Outputs
^ÇàìëíáåÖ=lìíéìí=qáãáåÖ
From the Output Menu, select Timing Adjust to display the Output Timing Adjust
Submenu. On this submenu, shown in the following illustration, you can change the
selected output's total, active and sync settings, and reposition video on the output.
OUT TIMING ADJUST
> H Total
H Position
H Active
H Sync
V Total
V Position
V Active
V Sync
Figure 4-34. Output Timing Adjust Submenu (sample)
In dual-channel mode, the Out Timing Adjust Submenu includes a field for selecting the
channel to work with.
OUT TIMING ADJUST
> Channel
H Total
H Position
In either mode, your settings:
•
•
•
•
On this menu:
•
•
•
•
•
60
Note All but the most advanced users are advised to avoid
changing the output timing values.
Do not result in cropping the image
Do not change the image aspect ratio
Must be within the range of timings supported by the output display, to avoid loss
of signal
Update the output Area of Interest
H Total — Adjusts (in pixels) the total pixel count per line for the selected output.
H Position — Adjusts (in pixels) the offset of the start of the output active area
from H sync.
H Active — Adjusts (in pixels) the horizontal size of the output active area.
H Sync — Adjusts (in pixels) the H sync width.
V Total — Adjusts (in lines) the total line count per frame.
2200
192
1920
88
1125
41
1080
5
A
A
2200
192
ImagePRO-II • User's Guide