Barco ImagePRO-II Jr User Manual Addendum page 59

4. Menu Orientation
Configuring Inputs
^ÇàìëíáåÖ=qáãáåÖ=m~ê~ãÉíÉêë
The ImagePRO-II supports adjusting the positioning of the input signal's active area. There
are two timing adjustment menus: 1:1 Timing Adjust and Edge Timing Adjust.
The 1:1 Timing Adjust Submenu displays the timing information of the input signal,
shown in the following illustration. Timing parameters are adjustable only when:
•
•
1:1 TIMING ADJUST
> Sample Phase
H Total
H Position
H Active
V Total
V Position
V Active
Figure 4-13. 1:1 Timing Adjust Submenu (sample)
The options are:
•
•
•
•
•
•
•
When 1:1 Sample is Off, the Timing Adjust Submenu changes to the Edge Timing
Adjust Submenu. For more information, refer to the
this page.
^ÇàìëíáåÖ=bÇÖÉ=qáãáåÖë
When the 1:1 Sample option is Off, the Edge Timing Adjust Submenu is available in
place of the Timing Adjust Submenu.
44
1:1 Sample is On and
The input signal is analog YP
Sample Phase — Initially, the value is set to the default value of 0.
The range is -16 to +15.
If the Sample Phase is n/a, then either 1:1 Sample is Off, or the input is not
analog YP P or RGB.
b r
H Total — This value is the total pixel count per line. This value cannot be
adjusted on the DVI-I or SDI connectors (Inputs 1 and 5).
H Position — Sets the offset of the start of the active area from H Sync.
H Active — Sets the size of the active area.
V Total — Displays the total line count per frame. This value cannot be changed
for any input.
V Position — Sets the offset of the start of the active area from V Sync.
V Active — Sets the size of the active area.
P or analog RGB
b r
n/a
1698
370
1280
1056
31
1024
Adjusting Edge Timings
ImagePRO-II • User's Guide
section on