Barco ImagePRO-II Jr User Manual Addendum page 133

4. Menu Orientation
Operating the ImagePRO-II in 3D Mode
iÉÑíLoáÖÜí=fã~ÖÉ=pï~ééáåÖ
The miniDIN-3 connectors on the ImagePRO-II rear panel determine which eye
corresponds to the current frame of single-stream 3D video. By default, on both inputs and
outputs:
•
•
You can swap these defaults for both inputs and outputs.

To swap the left and right input signals, select Input > Processing > 3D Swap. The
options are:
•
•
•
•

To swap the left and right output signals, select Output > 3D Swap. The options are
the same as those for input 3D Swap.
aáëéä~óáåÖ=~=içÖç=çê=Oa=fã~ÖÉ=áå=Pa=jçÇÉ
In 3D mode, you can capture, store, and restore a still image for use as a 3D logo. In this
scenario, two identical 2D images are paired (right and left eyes) to provide a 3D logo at a
maximum 2048x1200 per channel.
You work with logo images as described in "Using a Logo or Internal Black" on page 96.
However, in the Logo Menu, two additional fields indicate the presence or absence of the
logo on each channel.
118
The DVI connector takes the left eye and HDMI takes the right eye.
The SDI-1 connector takes the left eye and SDI-2 takes the right eye.
L/R. Processes the video as if the left image is the right, and the right image is on
the left.
R/L. Processes the video as if the right image is on the left, and the left image is
on the right.
L/L. Displays the left-eye video as a standard 2D image.
R/R. Displays the right-eye video as a standard 2D image.
Note The ImagePRO-II does not support pairing two different
images to be used as a 3D logo.
ImagePRO-II • User's Guide