Barco ImagePRO-II Jr User Manual Addendum page 26

2. Hardware Orientation
fåéìí=_ìííçåë
Input buttons 1 through 5 correspond to the five standard input connectors on the rear
panel. These buttons select the source signal that you want to display.
1
DVI-I
Figure 2-5. ImagePRO-II Input Buttons
The sixth button is reserved for use with the optional 3D/Dual Channel mezzanine.
•
•
•
•
•
•
For details about supported resolutions and HDCP compatibility for each input, refer to the
"Input Video
Specifications" section of Appendix A, on page 161.
qÜÉ=ildl=_ìííçå
The LOGO button beneath the input buttons can serve as an additional image source.
Using LOGO, you can capture, import, and store a still output frame in non-volatile
LOGO
memory, then transition to and from that still frame. For more information about using
LOGO, refer to the"
more information about transitioning, refer to the
qÜÉ=_i^`h=_ìííçå
The BLACK button transitions the display to and from black. For more information about
BLACK, refer to the
BLACK
qÜÉ=cow=_ìííçå
Pressing the FRZ button temporarily freezes the displayed video. If FRZ is lit, the following
actions turn it off:
FRZ
•
•
When you freeze an image, the PAN/ZOOM button is not operational, and the Input Setup
and Views menus are not accessible.
ImagePRO-II • User's Guide
2 3
HD-15 HDMI DP
Press Input Button 1 to select the source on the DVI (digital or universal analog)
connector.
Note A customer-supplied DVI to HD-15 adapter is required to
connect analog video to the DVI connector.
Press Input Button 2 to select the source on the HD-15 (universal analog)
connector.
Press Input Button 3 to select the source on the HDMI connector.
Press Input Button 4 to select the source on the DisplayPort connector.
Press Input Button 5 to select the source on the SDI-1 connector.
Press Input Button 6 to select the source on the SDI-2 connector, when the
3D/Dual Channel mezzanine is installed.
Connectors" section on page 13 of this chapter, or to the
Using a Logo or Internal
"Displaying Internal
Pressing FRZ again
Pressing the input button for the displayed image
4 5 6
SDI-1 SDI-2
Black" section of Chapter 4 on page 96. For
"Setting Transitions" section on page 83.
Black" section of Chapter 4 on page 100.
ImagePRO-II Front Panel
"Input
11