Barco ImagePRO-II Jr User Manual Addendum page 127

4. Menu Orientation
Operating the ImagePRO-II in Dual-Channel Mode
3.
4.
5.
oÉëíçêáåÖ=~=p~îÉÇ=içÖç=áå=aì~äJ`Ü~ååÉä=jçÇÉ

To restore a logo stored on a flash drive and assign it to a specific channel, use the
following procedure in dual-channel mode:
1.
2.
3.
4.
5.
6.
112
USB BACKUP LOGO
> Channel
LogoBackupCHA_1
Backup Logo
Figure 4-107. USB Backup Logo Submenu in Dual-Channel Mode
Either accept the default channel or change this selection and press SEL.
Scroll to the next line, which displays the default name for this logo. If you wish to
change the name, press SEL. Use the ADJUST knob to change the name, as
described in Saving a Custom Format
complete the name change.
Scroll to Backup Logo and press SEL.
A message confirms the success of the backup operation.
Insert the flash drive in the ImagePRO-II's front-panel USB port.
From the System Menu, select the USB Backup/Restore Submenu.
Select Restore Logo. The USB Restore Logo Submenu appears, as shown in
the following illustration.
USB RESTORE LOGO
> Channel
Logo1
Restore Logo
Figure 4-108. USB Restore Logo Submenu
Select the channel to which you wish to restore the logo. The logo will become
available on that channel.
On the next line, scroll through the list of stored logos. When you locate the file
you want, press SEL again.
Scroll to Restore Logo and press SEL.
A message confirms the success of the restore operation, and instructs you to
reboot the ImagePRO-II.
Note You must reboot the ImagePRO-II to use the restored logo.
A
on page 75. Press SEL again when you
A
ImagePRO-II • User's Guide