Barco ImagePRO-II Jr User Manual Addendum page 73

4. Menu Orientation
Configuring Outputs
•
•

To set or revert the output Area of Interest, use the following procedure:
1.
58
Figure 4-31. V Size Adjustment
H Pos — Using H Pos, you can move the image horizontally. The default value is
0, representing the left edge of the active area. Increasing the H Pos value moves
the image to the right. Decreasing the H Pos value moves the image to the left.
You can adjust H Pos only after adjusting H Size.
HPos / VPos = 0 pixels / 0 lines
H Pos = 400 pixels
V Pos = 0 lines
Figure 4-32. H Pos Adjustment from 0 to 400 pixels
V Pos — After adjusting the V Size, you can move the image vertically within the
output's active vertical limits.The default value is 0, representing the upper edge of
the active area. Increasing the V Pos value moves the image down. Decreasing
the V Pos value moves the image up.
H Pos = 0 pixels
V Pos = 200 lines
Figure 4-33. V Pos Adjustment from 0 to 200 lines
From the Output Menu, select Area of Interest. The Area of Interest Submenu
appears, showing default settings equal to the H and V actives of the output
timing.
ImagePRO-II • User's Guide