Working With Test Patterns - Barco ImagePRO-II Jr User Manual Addendum

4. Menu Orientation

Working with Test Patterns

oÉëíçêáåÖ=lìíéìí=`çåÑáÖìê~íáçå=aÉÑ~ìäí=s~äìÉë
To remove user-defined configuration settings and restore the default values for the current
output, select Reset Config from the Output Menu. If you select this command, custom
configurations are not restored the next time you power up the ImagePRO-II.
With the 3D/Dual Channel mezzanine installed and the system mode set to Dual2K, the
Out Reset Config Submenu appears. This submenu lets you restore the output
configurations on a per-channel basis. Every output mapped to the selected channel is
restored to its default settings.
tçêâáåÖ=ïáíÜ=qÉëí=m~ííÉêåë
As you configure outputs, you can set up test patterns. You can send one test pattern to all
outputs simultaneously in Standard system mode.
Test patterns appear within the output's Area of Interest (AOI). If the output image uses the
default AOI, the test pattern is displayed in the default active area. If you set up a custom
AOI for the output, the test pattern appears within that AOI. For more information, refer to
the Setting the Area of Interest
You can also set up raster boxes for both the AOI and the output active area. The following
illustration shows the Test Pattern Menu in the standard ImagePRO-II. Access this menu
by pressing the front-panel TEST PAT button.
TEST PATTERN
> Type
Raster Box
Diag Motion
AOI Raster Box
If you have the 3D/Dual Channel option installed, you can assign a test pattern to one or
both channels; the test pattern appears on any output mapped to the channel. The
following illustration shows the Test Pattern Menu in dual-channel mode.
TEST PATTERN
> Channel
AOI Type
AOI Raster Box
AOI Diag Motion
Out Raster Box
Figure 4-51. Test Pattern Menu in Dual-Channel Mode
70
on page 56.
Figure 4-50. Test Pattern Menu
Off
Off
Off
Off
All
Off
Off
Off
Off
ImagePRO-II • User's Guide