Barco ImagePRO-II Jr User Manual Addendum page 28

2. Hardware Orientation
Following are descriptions of each rear panel connector:
1)
2)
fåéìí=sáÇÉç=`çååÉÅíçêë
On the system's rear panel, each of the input connectors maps to a corresponding input
button on the front panel. For additional information about any connector, including pinouts
and a list of supported formats, refer to Appendix A, Specifications, on page 161.
3)
4)
5)
6)
7)
8)
lìíéìí=sáÇÉç=`çååÉÅíçêë
The user sets the output format. Output connectors are active only if they support the
selected format. If a connector cannot support the selected format, that connector is
deactivated. Therefore, all connectors may not be active at the same time.
The default output format is 1024x768 @ 59.94. You can select other formats for an output,
or define custom formats. Outputs revert to the last saved state on power-up.
Output colorspace is adjustable for the HD-15, DVI, HDMI, and DisplayPort connectors.
For additional information about any connector, including pinouts and a list of supported
formats for each connector, refer to Appendix A, Specifications, on page 161.
9)
10) Composite Video Output
11) DVI-D Output
12) Universal Analog Output
13) HDMI Output
ImagePRO-II • User's Guide
AC Connector
One AC Connector with a power switch is provided to connect the ImagePRO-II
to your facility's AC power source through the supplied power cord. The integral
switch turns the unit on and off.
100-240 VAC, 47-63 Hz
Ethernet Port
One RJ-45 connector is provided for 10/100BaseT Ethernet communications
with the ImagePRO-II. The port is used for running the Web Interface, for
diagnostics, and for connection to an external device such as the Encore or
ScreenPRO-II Controller.
The Ethernet connector is compatible with:
~
Standard RJ-45 Ethernet cables
~
Neutrik EtherCon
For pinout details, refer to the
Appendix A, on page 169.
Input 1 — DVI-I Input with Loop-through
Input 2 — Analog Input with Loop-through
Input 3 — HDMI Input
Input 4 — DisplayPort Input
Input 5 — SDI-1 Input with Loop-through
Input 6 — SDI-2 Input with Loop-through
SDI-1 Output
®
series cables
"Standard Connector
ImagePRO-II Rear Panel
Pinouts" section in
13