Lexmark MS31x/41x/510/610 & MX310/410/51x/61x Product Study Guide
Trailing Edge Sensor
The removal procedure of this newly-added sensor is lengthy. There are at least nine parts to be removed
and important instructions to be followed closely upon installation. See the printer's Service Manual for
the removal and installation procedures. And take note of the following tips on how to properly seat the
Trailing Edge Sensor cables:
Below are tips on how to properly seat the cables of the Trailing Edge Sensor:
•
Always route the cables along the cable holders.
•
If the cables are long and/or hanging loosely, twist them and make sure it's tightly looped around
the cable holders.
•
Route the cable as shown below, and secure it with a cable tie (A).
For Training Purposes Only
79
Rev 1.3
4/21/2014