Firmware Version 1.0.1.22 - Grandstream Networks UCM6100 Series User Manual


Added sample Email settings. [EMAIL SETTINGS]

Added manual time settings. [TIME SETTINGS]

Added "Enable Pick Extension" and "Extension Segment" options for auto provisioning settings.

Changed one of the discovery method from "SIP MESSAGE (OPTIONS)" to "SIP MESSAGE
(NOTIFY)" in zero-config feature.

Added pickup group feature. [Table 76: UCM6100 Feature Codes]

Added PSTN detection instructions for "Auto Detect" and "Semi-auto Detect". [PSTN DETECTION]

Added "Auth ID" option for SIP register trunk configuration. [Table 50: Create New SIP Trunk]

Added LDAP sync options for peer SIP trunk. [Table 50: Create New SIP Trunk]

Changed the default setting of outbound route "Privilege Level" from "Internal" to "International" to
avoid potential misconfiguration and security risk.

Added DISA and Fax to IVR key press event options. [Table 62: IVR Configuration Parameters]

Added "Min Message Time" option in voicemail settings. [Table 63: Voicemail Settings]

Added Fax setting samples. [FAX/T.38]

Added DISA support for inbound route and IVR.

Added Event List support to monitor local extensions and remote extensions. [BLF AND EVENT LIST]

Added feature code *0 for "Disconnect". [Table 76: UCM6100 Feature Codes]

Added feature code *8 for "Pickup Extension" in pickup group feature. [Table 76: UCM6100 Feature
Codes]

Added "Record Prompt" and "Custom Name of Pickup Group" options in internal options. [Table 77:
Internal Options/General]

Added warning information for "Allow Guest Call" option to avoid potential security risk caused by
misconfiguration. [Table 81: IAX Settings/General]

Changed reset mode to two mode "User Data" and "All". [RESET AND REBOOT]

FIRMWARE VERSION 1.0.1.22


This is the initial version.
Firmware Version 1.0.10.39 UCM6100 Series IP PBX User Manual Page 25 of 331