Omron NJ Series Troubleshooting Manual page 79

Event code Event name
54010413 hex Undefined CJ-
series Memory
Address
54010414 hex Stack Underflow
54010416 hex Illegal Number of
Array Elements or
Dimensions
54010417 hex Specified Task
Does Not Exist
54010418 hex Unallowed Task
Specification
54010419 hex Incorrect Data
Type
5401041A hex Multi-execution of
Instructions
5401041B hex Data Capacity
(Ver. 1.02) Exceeded
5401041C hex Different Data
(Ver. 1.04) Sizes
54010800 hex FINS Error
54010801 hex FINS Port Already
in Use
54010C00 hex Illegal Serial Com-
munications Mode
54010C02 hex Port Setup Already
Busy
NJ-series Troubleshooting Manual (W503)
Meaning
The required specification • The required AT speci-
is missing for a variable for
which CJ-series Unit mem-
ory must be specified.
There is no data in a stack. • An attempt was made
The valid range was • The valid range was
exceeded for the number of
array elements or dimen-
sions in an array I/O param-
eter for an instruction.
The task specified for the • The specified task
instruction does not exist.
An unallowed task was • The local task, the pri-
specified for an instruction.
A data type that cannot be • A data type that can-
used for an instruction is
specified for an input or in-
out variable.
Multi-execution was speci- • Execution of an
fied for an instruction that
does not support it.
Processing was not possi- • Data that exceeded
ble because the data that
was passed to the instruc-
tion was too large.
The size of the data speci- • Data of a size that is
fied for instruction input or
in-out data is different from
the size of the target
parameter.
An error occurred when a • An error occurred
FINS command was sent
or received.
The FINS port is being • The FINS port is being
used.
The Serial Communica- • The serial communi-
tions Unit is not in the serial
communications mode
required to execute an
instruction.
A Change Port Setup • A Change Port Setup
instruction was executed
during execution of another
Change Port Setup instruc-
tion.
Assumed cause
Maj Prt
fication is missing for a
variable for which CJ-
series Unit memory
must be specified.
to read data from a
stack that contains no
data.
exceeded for the num-
ber of array elements
or dimensions in an
array I/O parameter for
an instruction.
does not exist.
mary periodic task, or
a periodic task was
specified.
not be used for an
instruction is specified
for an input or in-out
variable.
instruction that does
not support multi-exe-
cution of instructions
was specified more
than once.
the size that can be
processed was
passed to an instruc-
tion.
different from the size
of the target parame-
ter was specified for
the input or in-out data
of an instruction.
when a FINS com-
mand was sent or
received.
used.
cations port for the
Serial Communica-
tions Unit is not set to
the mode expected by
the instruction.
instruction was exe-
cuted during execution
of another Change
Port Setup instruction.
3 Error Tables
Level
Refer-
ence
Min Obs Info
S NJ-series
Instruc-
tions Ref-
erence
Manual
(Cat. No.
W502)
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
3-17
3