Omron NJ Series Troubleshooting Manual page 118

3 Error Tables
Event code Event name
544F 0000 hex Setting Out of
Range for
Writing MC
Setting
54500000 hex Trigger Input
Condition
Mode Selec-
tion Out of
Range
54510000 hex Drive Trigger
Signal Selec-
tion Out of
Range for
Trigger Input
Condition
54530000 hex Motion Con-
trol Instruc-
tion Re-
execution
Disabled
(Axis Specifi-
cation)
54540000 hex Motion Con-
trol Instruc-
tion Re-
execution
Disabled
(Buffer Mode
Selection)
54550000 hex Motion Con-
trol Instruc-
tion Re-
execution
Disabled
(Direction
Selection)
54560000 hex Motion Con-
trol Instruc-
tion Re-
execution
Disabled
(Execution
Mode)
3-56
Meaning Assumed cause
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
SettingValue input input variable.
variable to a motion
• The parameter specification
control instruction is
and the data type of the setting
out of range.
value do not agree.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
TriggerInput:: Mode input variable.
input variable to a
motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
TriggerInput::Input- input variable.
Drive input variable
to a motion control
instruction is out of
range.
An attempt was • A parameter for an input vari-
made to change the able that cannot be changed for
parameter for the re-execution was changed.
Axis input variable
when re-executing
a motion control
instruction. (This
input variable can-
not be changed
when re-executing
an instruction.)
An attempt was • A parameter for an input vari-
made to change the able that cannot be changed for
parameter for the re-execution was changed.
BufferMode input
variable when re-
executing a motion
control instruction.
(This input variable
cannot be changed
when re-executing
an instruction.)
An attempt was • An input variable that cannot be
made to change the changed for re-execution was
parameter for the changed.
Direction input vari-
able when re-exe-
cuting a motion
control instruction.
(This input variable
cannot be changed
when re-executing
an instruction.)
An attempt was • A parameter for an input vari-
made to change the able that cannot be changed for
parameter for the re-execution was changed.
Periodic input vari-
able when re-exe-
cuting a motion
control instruction.
(This input variable
cannot be changed
when re-executing
an instruction.)
Level
Maj Prt Min Obs Info
S NJ-series
Motion Con-
trol Instruc-
tions
Reference
Manual (Cat.
No. W508)
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
NJ-series Troubleshooting Manual (W503)
Reference