Table of Contents
Advertisement
Ø
Keep hands clear of the bottom of the spindle during operation.
Ø
Do not operate the machine with the covers removed.
Ø
Use extreme caution when inserting or removing cutters
Ø
Before servicing, disconnect the power cord.
Ø
To avoid electric shock or equipment damage, connect power to this machine according to
this guide and in compliance with all applicable laws and regulations.
Ø
Never operate the equipment with damaged or frayed power cords, loose connections, or
exposed extension cords where the cord could create a tripping hazard.
Ø
Be sure to hold the plug, not the cord, when disconnecting the machine from a power source.
Ø
Keep work area clean. Remove adjustment tools from the machine prior to start-up. Cluttered
work areas increase the potential for accidents.
Ø
Safety glasses should be worn at all times as chips and other debris may become airborne.
Ø
Avoid loose clothing, neckties, gloves, rings, bracelets, jewelry and other items that may get
caught in moving parts.
Ø
If your machine does not operate properly; in particular, if there are any unusual sounds or
smells coming from it, immediately unplug it and contact Vision's service department or your
local distributor.
Ø
Unplug the machine when it is going to be left unused for an extended period of time.
Ø
Operators should inspect the machine daily for damage or modifications. Under no
circumstances should the machine be operated if there is any doubt about the machine
condition. If there are any questions call the Vision technical support team at 602-439-0600.
Ø
Keep a safe distance away from the machine while running.
Ø
Keep children away from work area at all times. Visitors should be a at least 3 feet from
working area.
Ø
Do not operate this or any machine while under the influence of drugs or alcohol.
Ø
Keep hands away from the spindle at all times when spindle is rotating and/or machine is
moving. Always wait for spindle to stop rotating before attempting to insert or change a tool.
© 2018 Vision Engraving & Routing Systems
Introduction
9
Advertisement
Table of Contents
