Table of Contents
Advertisement
74
Vision VE810 S5 User Manual
Burnishing is different than standard rotary engraving mainly because the nose cone is not used to set
the depth of cut. Burnishing does not actually cut deep into metals, rather it cuts the painted surface off
of metals. To effectively burnish, it is recommended to use an optional EZ Rider burnishing adapter. This
helps to control the pressure of the cutter applied to the material. Burnishing requires less pressure than
other types of engraving and the EZ Rider attachment applies the proper amount of pressure for
burnishing.
Installing the EZ Rider is similar to using a cutter knob. First, screw the EZ Rider into the top of the
spindle hand tight. Next, insert the cutter through the EZ Rider and spindle so that the cutter sticks out
below the nose cone approximately 1/4 inch (6 mm). Tighten the set screw in the EZ Rider to hold the
cutter in place.
© 2018 Vision Engraving & Routing Systems
Advertisement
Table of Contents
