Quick Lock Vise - Vision VE810 S5 User Manual

142 Vision VE810 S5 User Manual
8.2

Quick Lock Vise

The Quick Lock Vise is used to clamp rigid materials against the top Edge Guide in order to prevent
movement. This is an alternate method for holding down materials.
Put the material you would like to engrave on the t-slot table and push it to the home position corner.
Next, loosen the quick lock vise locking screw and slide the quick lock vise so that there is about 1/16th
inch gap between the edge of the vise and the material. Tighten the quick lock vise locking screw. Once
this is done, the material can easily be secured by turning the quick lock vise handle. When changing
the engraving material, simply loosen the quick lock vise handle, remove the engraved material, put the
new material in and tighten up the quick lock handle.
Note: For larger pieces of material, you may need to put a small piece of double-sided tape on the tslot
table in the middle of the engraving material. This will keep the material from bowing in the center.
The quick lock vise will only work on square or rectangular material. To hold down irregular shaped
objects, you must use some other method. Ask your Vision Distributor or Vision if you need more
information on this feature.
© 2018 Vision Engraving & Routing Systems