Adjusting Spindle Pressure - Vision VE810 S5 User Manual

118 Vision VE810 S5 User Manual
5.6.5

Adjusting Spindle Pressure

In some cases, the pressure applied by the spindle (when engraving with the proximity sensor), will need
to be adjusted. The Spindle Pressure Spring Adjustment knob can be turned to increase or decrease the
amount of pressure. The pictures below show the location of this knob.
To change the engraving pressure, the knob must be rotated, which changes the preload on the spring,
and therefore the amount of pressure applied by the cutter tip on to your material. This is normally
performed for diamond drag engraving only. More pressure will produce a deeper engraving. To increase
the engraving pressure, the knob must be rotated clockwise (when viewed from the top of the machine).
In order to access this knob and turn it, turn the machine off, then turn the knob clockwise to increase
pressure and counterclockwise to decrease pressure.
© 2018 Vision Engraving & Routing Systems