Table of Contents
Advertisement
Maintenance
131
Back Cover Screws
Remove the five back cover screws (shown below). The center screw does not absolutely need to be
removed. It holds a cable clamp inside the back cover of the machine. To remove the center screw, reach
inside the machine with a 11/32" nut driver to hold the nut and remove the screw with a Phillips
screwdriver from the back of the machine.
Spindle Cover
To remove the spindle cover, slide the cover up. Squeezing the sides of the cover will facilitate removal.
© 2018 Vision Engraving & Routing Systems
Advertisement
Table of Contents
