Machine Description & Terminology - Vision VE810 S5 User Manual

12 Vision VE810 S5 User Manual
2.2 Machine Description & Terminology
This chapter briefly describes the major components of the VE810 engraving system. This chapter will
help you identify the parts of your machine discussed in this manual.
TABLE SPECIFICATIONS:
Z-Axis Clearance:
(Definition: the distance between the bottom of the spindle and the work surface)
Z-Axis Stroke:
(Definition: the travel distance of the Z-axis mechanism or spindle)
Table Resolution:
(Definition: the smallest controlled motion the table is capable of)
Engraving Area: 8 x 10 inches (203.2 x 254 mm)
Overall Dimensions:
Table Top:
Shipping Weight:
Actual Weight:
Shipping Dimensions:
DEFINITION OF TERMS
1. X-Axis Leadscrew - The screw that drives the left to right motion of the machine.
2. X-Axis Linear Rails - The 1/2 inch (12.7 mm) round rails that the carriage assembly rides on.
3. Y-Axis Linear Rails - The 1/2 inch (12.7 mm) round rails that the t-slot table rides on.
4. Y-Axis Leadscrew - The screw that drives the front to back motion of the machine.
5. T-Slot Table - Also referred to as the work surface, this aluminum bed supported by the Y-Axis
linear rails, allows placement of the engraving material or special clamps and fixtures. The slots in the
table are shaped with an upside-down T, with the bottom of the T being a single-line slot across the
top of the table. The slots are used to hold various accessory holders, clamps, and fixtures.
6. Touch Screen - This is the area in which you control the table movement. You can start, stop,
pause, cancel a job and set the spindle surface. Also, you can control the speed at which the table
moves and the spindle RPM.
7. Quick Lock Vise - This is the clamp assembly that is included with the Vision VE810 engraving
system. It allows you to lock your material on the T-Slot table.
8. Table Home Position - The upper-left corner of the T-Slot table. All work is referenced from this
position.
9. Spindle - This is the part where the engraving cutters are inserted and adjusted for depth of cut.
10. Spindle Motor Pulley - The spindle motor pulley is mounted to the top of the spindle motor and
drives the motor belt. The motor belt drives the spindle, enabling it to rotate the cutting tool. (The
spindle motor pulley is hidden by the spindle cover. In order to see it, you must remove the cover)
1 inch (25.4 mm)
1 inch (25.4 mm)
.001 inch (0.025 mm)
14 1/2 x 19 x 22 inches (H x W x D)
36.8 x 48.3 x 55.9 cm (H x W x D)
Removable T-Slot
65 lbs. (29.5 kg)
45 lbs. (20.4 kg)
27 x 22 x 19 inches
68.6 x 55.9 x 48.3 cm
© 2018 Vision Engraving & Routing Systems