Vision VE810 S5 User Manual page 128

128 Vision VE810 S5 User Manual
Apply isopropyl alcohol to a paper towel and wipe down the Y-Axis leadscrews and the stainless steel
rails for the t-slot table.
NOTE: Clean the leadscrew, rail and baseplate (the area underneath the table) with the table in the fully
extended (forward) and fully retracted positions.
Raise and lower the spindle to access the upper and lower sections of the spindle rail. The rail is located
behind the spindle. Apply isopropyl alcohol to a paper towel and wipe down the sides and front of the
spindle rail.
© 2018 Vision Engraving & Routing Systems