Vision VE810 S5 User Manual page 13

VE810 Top View
11. Z-Axis Leadscrew - This drives the spindle up and down while engraving.
12. Down Pressure Spring Adjust - This knob adjusts the amount of pressure that the spindle applies
to the material when engraving. When viewed from the top, turning the knob clockwise will increase
pressure and turning it counter-clockwise will decrease pressure.
13. Spindle Pulley - This is the top part of the spindle where the motor belt rides.
14. Spindle Micrometer - This is the part of the spindle that you adjust to set the depth of engraving.
Turning it to the right (counter-clockwise when viewed from the top) will create deeper engraving.
15. Spindle Nose Cone - This is the part of the spindle that rides on the material while engraving. The
cutter protrudes from the bottom of the nose cone creating your depth of cut.
© 2018 Vision Engraving & Routing Systems
General Information 13