Creating A Center Driver - Vision VE810 S5 User Manual

110 Vision VE810 S5 User Manual
In Order to make sure we will be located properly we will use the machines dry run feature. Send the file
to the engraver. Instead of pressing play on the touch screen, press the magnifying glass.
This will turn the laser on and allow us to preview a box around the area that will be engraved.
5.6.4

Creating a Center Driver

In this section, a custom driver will be created based on the VE810 S5 Vise driver that will allow the user
to set a home position in the center of an engraving area. The Vision 10 software will automatically
position the job based on this center location. An illustration of this process is shown below.
For simplicity in this example, a circular piece of acrylic will be engraved. The material is 3 inches in
diameter, and an engraving area of 1.75" x 0.75" needs to be centered on the piece of acrylic.
Referencing the drawing below, the job will be quickly set up using a custom "Center" driver.
© 2018 Vision Engraving & Routing Systems