Table of Contents
Advertisement
The Front Panel
45
Set Offset
To set an offset location press the offset number button until you reach the desired number. Offset
number 1 is always reserved for the machine home (upper left corner 0,0,0) and can not be overwritten.
Offset number 9 is reserved for the vise offset and can only be changed using the vise button on the tools
screen as described later in this section. After selecting the desired offset number press the X and Y
jog buttons to move the spindle to the desired location. With the spindle at the desired offset location,
press the blue plus Set button to save this location under the offset number displayed on the screen.
The user can also set the offset by using the laser pointer. After selecting the desired offset number
press the laser pointer (magnifying glass) button and the laser pointer will turn on. Next use the X and Y
jog keys to move the laser pointer to the desired offset location. As before press the blue plus Set
button to save this location under the offset number displayed on the screen. Pressing the green check
button will always move the spindle to the offset location corresponding to the offset number displayed on
the screen.
Set Surface
Press the Z+ and Z- buttons and jog the spindle/cutter to the surface. Press the set surface button.
Surface will now display the current Z axis location above the surface.
© 2018 Vision Engraving & Routing Systems
Advertisement
Table of Contents
