Table of Contents
Advertisement
48
Vision VE810 S5 User Manual
Vise
The vise button is used to set the center location of a self centering vise. Place the vise on the t-slot
table and secure it with the supplied t-nuts. In the tools screen press the vise button and the vise
location screen will appear. Press the X and Y jog buttons on this screen until the laser pointer is in the
center of the vise. Press the green check mark (select) button and the vise offset is now set.
Go to Location Screen
The Go to Location screen is used to move the spindle to a specific location on the engraving area.
Press the X button and the X display will turn red. Then type in the location using the number pad. Press
the Y button and type in the location using the number pad. Then press the green check mark. The
spindle will move to that exact location.
© 2018 Vision Engraving & Routing Systems
Advertisement
Table of Contents
