Vision VE810 S5 User Manual page 126

126 Vision VE810 S5 User Manual
Back Cover Screws
Remove the five back cover screws (shown below). The center screw does not absolutely need to be
removed. It holds a cable clamp inside the back cover of the machine. To remove the center screw, reach
inside the machine with a 11/32" nut driver to hold the nut and remove the screw with a Phillips
screwdriver from the back of the machine.
Spindle Cover
To remove the spindle cover, slide the cover up. Squeezing the sides of the cover will facilitate removal.
© 2018 Vision Engraving & Routing Systems