Table of Contents
Advertisement
The Front Panel
47
Tools Screen
The Tools Screen contains ten buttons and one slider that is associated with the spindle button. The X
button exits this screen and jumps to the screen above. The vise button is used to set the location of the
center of a vise if used on this machine. The inch button toggles the screen units between inch and mm.
The Laser Offset button is used to set the laser pointer offset on the machine at the factory. The Laser
button turns the laser pointer on and off and will be Red when off and blank when on. The Aux 1 button
is used to manually turn the Remote Vacuum Port On or Off and will be Red when off and blank when on.
Aux 2 and Aux 3 buttons are not used on the VE810 S5 machine. The Fan button turns the cooling fan
On or Off and will be Red when off and blank when on. The Spin button turns the Spindle On or Off and
works in conjunction with the slider next to it which sets the Spindle RPM's. This screen is used to test
or troubleshoot these functions of the machine.
© 2018 Vision Engraving & Routing Systems
Advertisement
Table of Contents
