Table of Contents
Advertisement
Step by Step Operation
107
The plate size is automatically resized in the software.
5.6.3
Using the Red Dot Laser Pointer for Positioning
A common and easy way to position text and graphics is to use the Red Dot Laser Pointer along with an
outline of the area to be engraved in the Vision 10 Software. The Following example will walk the user
through the process.
In this example, a 3 inch diameter piece of acrylic will be used and a circular engraving area will be
designed. If you are using a rectangular item, the process will be very similar and differences are noted
here detailing the variations in the job set up.
First place the material somewhere on the table. (If using a square item make sure it is square to the
table edge guides) In this example, multi mat is used to hold down the piece of acrylic. Next install a
cutter in the spindle and adjust it so the tool is extending past the nose cone.
© 2018 Vision Engraving & Routing Systems
Advertisement
Table of Contents
