Vision VE810 S5 User Manual page 72

72 Vision VE810 S5 User Manual
Select the Engrave Icon to send the file to the engraver.
Place the material on the table (shown with Multi Mat on the t-slot table to hold the engraving material in
place), and press the start button on the machine to begin engraving.
NOTE: The design of the Vacuum Chip Removal System is to clear the debris away from the engraved
material and prevent the chips from scratching the surface of the material during operation, and/or getting
trapped between the nose cone and the material (when using the proximity sensor function) and causing
the engraver to not engrave to the proper depth.
© 2018 Vision Engraving & Routing Systems