Plc Run Mode Selections - Veichi AC300 Series Technical Manual

AC300 Series Vector Control Inverter Manual
Multi-speed terminal Multi-speed terminal Multi-speed terminal
4 3 2
OFF OFF OFF
OFF OFF ON
OFF OFF ON
OFF ON OFF
OFF ON OFF
OFF ON ON
OFF ON ON
ON OFF OFF
ON OFF OFF
ON OFF ON
ON OFF ON
ON ON OFF
ON ON OFF
ON ON ON
ON ON ON
K1
K2
K3
K4
K5
K6
Terminal connection
Function Parameter Specifications
Multi-speed terminal terminal
1 speed
ON 1X［F12.00］
OFF 2X［F12.01］
ON 3X［F12.02］
OFF 4X［F12.03］
ON 5X［F12.04］
OFF 6X［F12.05］
ON 7X［F12.06］
OFF 8X［F12.07］
ON 9X［F12.08］
OFF 10X［F12.09］
ON 11X［F12.10］
OFF 12X［F12.11］
ON 13X［F12.12］
OFF 14X［F12.13］
ON 15X［F12.14］
inverter
X1 FWD/STOP
X2 REV/STOP
X3
Multistep terminal 1
X4
Multistep terminal 2
X5
Multistep terminal 3
X6
Multistep terminal 4
COM common terminal
138
AC300 Series Vector Control Inverter Manual
frequency
5X
4X
3X
2X
1X
multi steps terminal 4(X6)
ON
multi steps terminal 3(X5)
ON
multi steps terminal 2(X4)
ON ON ON
multi steps terminal 1(X3)
REV(X3)
ON
FWD(X3)
F12.15

PLC run mode selections

Setting range: 0000-2212
Select PLC running mode while program given.
LED "0" digit: cycle mode
0: Stop after single cycle While receiving order, inverter run from the first step, time unit is set by [F12.15] LED "00"
digit. Running time is set by [F12.16-F12.30]. Running direction and ACC/DEC time is selected by [F12.31-F12.45].
Turn to next step while run time is over, run time, direction, ACC/DEC time of every step can be set separately. Inverter
output 0 Hz while finished 15 steps running. If one step running time is 0, it will skip this step.
1: Continuous cycles Inverter not stop and runs at the latest speed while finished 15 steps running. Time unit is set
by [F12.15] LED "00" digit. Run time is set by [F12.16-F12.30]. Run direction and ACC/DEC time is selected by
[F12.31-F12.45].
2: Keep final value after single cycle Inverter back to 1
[F12.15] LED "00" digit. Run time is set by [F12.16-F12.30]. Run direction and ACC/DEC time is selected by
[F12.31-F12.45].
Note: PLC ACC/DEC time is set by [F12.31-F12.45] LED "00", and not be affected by terminal selection.
Function Parameter Specifications
6X
7X
8X
9X
10X
time
11X
12X
13X
14X
15X
ON
ON
ON ON ON
ON ON ON ON ON
ON
MULTI STEP TIME ORDER
Factory set: 0000
st step while finished 15 steps running. Time unit is set by
139