NetApp StorageGRID Webscale SG5700 Series Hardware Installation And Maintenance Manual page 27

Port
1 Two interconnect ports
on each controller
2 Management port 1 on
the E2800 controller
Management port 2 on
the E2800 controller
3 Management port 1 on
the E5700SG
controller
Management port 2 on
the E5700SG
controller
4 10/25-GbE ports 1-4
on the E5700SG
controller
Steps
1. Connect the E2800 controller to the E5700SG controller, using two optical cables and four of the
eight SFP+ transceivers.
Type of port Function
16Gb/s FC optical Connect the two controllers to each
SFP+ other.
1-Gb (RJ-45) Ethernet Connects to the network where you
access SANtricity System Manager.
You can use the Admin Network for
StorageGRID Webscale or an
independent management network.
1-Gb (RJ-45) Ethernet Reserved for technical support.
1-Gb (RJ-45) Ethernet Connects the E5700SG controller to the
Admin Network for StorageGRID
Webscale.
1-Gb (RJ-45) Ethernet Can be used to connect the E5700SG
controller to a service laptop during
installation, if a DHCP-assigned IP
address is not available.
10-GbE or 25-GbE Connect to the Grid Network and the
Client Network for StorageGRID
Note: The SFP+
Webscale. See "10/25-GbE port
transceivers
connections for the E5700SG
included with the
controller."
appliance support
10-GbE link speeds.
If you want to use
25-GbE link speeds
for the four network
ports, you must
provide SFP28
transceivers.
Installing the hardware | 27