Rebooting The E5700Sg Controller While The Storagegrid Webscale Appliance Installer Is Running - NetApp StorageGRID Webscale SG5700 Series Hardware Installation And Maintenance Manual

56 | Hardware Installation and Maintenance Guide for SG5700 Appliances
b. If you receive no response from the ping, confirm you are using the correct IP address.
You can use the IP address of the appliance on the Grid Network, the Admin Network, or the
Client Network.
c. If the IP address is correct, check appliance cabling, SFP transceivers, and the network setup.
If that does not resolve the issue, contact technical support.
d. If the ping was successful, open a web browser.
e. Enter the URL for the StorageGRID Webscale Appliance Installer:
http://E5700SG_Controller_IP:8080
The Home page appears.
Rebooting the E5700SG controller while the StorageGRID
Webscale Appliance Installer is running
You might need to reboot the E5700SG controller while the StorageGRID Webscale Appliance
Installer is running. For example, you might need to reboot the controller if the installation fails.
About this task
This procedure only applies when the E5700SG controller is running the StorageGRID Webscale
Appliance Installer. Once the installation is completed, this step no longer works because the
StorageGRID Webscale Appliance Installer is no longer available.
Steps
1. From the menu bar of the StorageGRID Webscale Appliance Installer, click Advance > Reboot
Controller.
The Reboot Controller page appears.
2. Click Reboot Controller.
A confirm dialog box appears.
3. Confirm you want to reboot the controller.
The E5700SG controller is rebooted.