NetApp StorageGRID Webscale SG5700 Series Hardware Installation And Maintenance Manual page 21

Information needed
Port bond mode
Switch port for port 1 (Client Network for Fixed
mode)
Switch port for port 2 (Grid Network for Fixed
mode)
Switch port for port 3 (Client Network for Fixed
mode)
Switch port for port 4 (Grid Network for Fixed
mode)
Table 4: Information needed to connect the E5700SG controller to the Grid Network
The Grid Network for StorageGRID Webscale is a required network, used for all internal
StorageGRID Webscale traffic. The appliance connects to the Grid Network using the 10/25-GbE
ports on the E5700SG controller.
See "10/25-GbE port connections for the E5700SG controller" for more information about
Note:
the options for these ports.
Information needed
Network bond mode
VLAN tagging enabled
VLAN tag
(if VLAN tagging is enabled)
DHCP-assigned IP address for the Grid
Network, if available after power on
If the Grid Network includes a DHCP
Note:
server, the E5700SG controller displays the
DHCP-assigned IP address for the Grid
Network on its seven-segment display after it
boots up.
Static IP address you plan to use for the
appliance Storage Node on the Grid Network
Note: If your network does not have a
gateway, specify the same static IPv4 address
for the gateway.
Preparing for installation | 21
Your value
Choose one:
• Fixed (default)
• Aggregate
Your value
Choose one:
• Active-Backup (default)
• LACP (802.3ad)
Choose one:
• No (default)
• Yes
Enter a value between 0 and 4095:
• IPv4 address (CIDR):
• Gateway:
• IPv4 address (CIDR):
• Gateway: