NetApp StorageGRID Webscale SG5700 Series Hardware Installation And Maintenance Manual page 22

22 | Hardware Installation and Maintenance Guide for SG5700 Appliances
Information needed
Grid Network subnets (CIDR)
If you are not using the Client
Note:
Network, the default route will automatically
be added to the Grid Network.
Table 5: Information needed to connect the E5700SG controller to the Client Network
The Client Network for StorageGRID Webscale is an optional network, used to provides client
protocol access to the grid. The appliance connects to the Client Network using the 10/25-GbE ports
on the E5700SG controller.
See "10/25-GbE port connections for the E5700SG controller" for more information about
Note:
the options for these ports.
Information needed
Client Network enabled
Network bond mode
VLAN tagging enabled
VLAN tag
(if VLAN tagging is enabled)
DHCP-assigned IP address for the Client
Network, if available after power on
Static IP address you plan to use for the
appliance Storage Node on the Client Network
If the Client Network is enabled, the
Note:
default route on the controller will use the
gateway specified here.
Related concepts
10/25-GbE port connections for the E5700SG controller
Related tasks
Configuring the hardware
Your value
Your value
Choose one:
•
•
Choose one:
•
•
Choose one:
•
•
Enter a value between 0 and 4095:
•
•
•
•
on page 33
No (default)
Yes
Active-Backup (default)
LACP (802.3ad)
No (default)
Yes
IPv4 address (CIDR):
Gateway:
IPv4 address (CIDR):
Gateway:
on page 17