NetApp StorageGRID Webscale SG5700 Series Hardware Installation And Maintenance Manual page 36

36 | Hardware Installation and Maintenance Guide for SG5700 Appliances
5. For step 1 of the Configure Management Ports wizard, make sure Port P1 is selected, and click
Next.
6. For step 2 of the Configure Management Ports wizard, configure the network settings for port
1.
a. From the Speed and duplex mode drop-down list, make sure Auto-negotiate is selected.
You must also make sure the Ethernet switch for the management network is set to
autonegotiate. Connectivity issues might occur if automatic negotiation is selected in
SANtricity System Manager but not set for the Ethernet switch.
b. Depending on your network configuration, select Enable IPv4, Enable IPv6, or both.
7. If you selected Enable IPv4:
a. Click Next.