NetApp StorageGRID Webscale SG5700 Series Hardware Installation And Maintenance Manual page 32

32 | Hardware Installation and Maintenance Guide for SG5700 Appliances
Code Indicates
HA StorageGRID Webscale is running.
E5700SG controller error codes
These codes represent error conditions that might be shown on the E5700SG controller as the
appliance boots up. Additional two-digit hexadecimal codes are displayed if specific low-level
hardware errors occur. If any of these codes persists for more than a second or two, or if you are
unable to resolve the error by following one of the prescribed troubleshooting procedures, contact
technical support.
Code
22
23
2A, 2B
40
41
42
51
92 to 96
A0 to A3
AB
AE
EA
E8
EU
EP
Related references
Troubleshooting the hardware installation
Related information
NetApp Support
Indicates
No master boot record found on any boot device.
The internal flash disk is not connected.
Stuck bus, unable to read DIMM SPD data.
Invalid DIMMs.
Invalid DIMMs.
Memory test failed.
SPD reading failure.
PCI bus initialization.
SATA drive initialization.
Alternate boot code.
Booting OS.
DDR4 training failed.
No memory installed.
The installation script was not found.
Installation or communication with the E2800 controller has failed.
on page 54