Power-Off Process; Interfaces; Operator Control Panel; Figure 2-12: Post Startup Logo Screen - Overland Storage ARCvault Series Service Manual

Section 2
3. The POST process begins and displays the Startup screen
NOTE:
After approximately 50 seconds, the unit automatically displays the Default menu screen
(Figure
After approximately 3 minutes, when the unit has completed its POST (including an inventory
of cartridges), it is ready for use.

2.3.2 Power-Off Process

At the OCP, press Power > Power Off to have the library perform a controlled shutdown.
Alternately, pressing and holding the Power button on the rear panel for 4 seconds shuts off power
without parking the shuttle and completing tasks.

2.4 Interfaces

There are two ways to interact with an ARCvault library: the Operator Control Panel (OCP) and
the Remote Management Utility (RMU).

2.4.1 Operator Control Panel

The OCP touch screen provides an easy way to make common configuration changes and control
access to the media. The following is a basic list of operational procedures and general instructions
for using the OCP touch screen.
• Virtual buttons are represented on the screen as rectangles with labels such as "Status." Press
inside the rectangle to activate the button's feature or submenu.
• A keyboard or set of option buttons is automatically displayed when numbers need to be
entered or specific selections are required.
• If more options are available than can fit on the screen, arrow buttons are displayed on the
bottom so you can scroll through the options. Only one arrow is shown when you reach the end
or beginning of the list.
NOTE:
2–8

Figure 2-12: POST Startup Logo Screen

You can press the Continue button on the Startup screen to view the Default screen. However,
the ARCvault will not allow any changes to its settings until POST completes.
2-13).

Figure 2-13: OCP Default Screen

The Status screen, Help screen, and all message screens use scroll bar arrows on the right side
in place of the Up/Down arrows.
(Figure 2-12).
10400025-101 10/2006