Reinstalling The Drive Assembly; Figure 4-11: Attaching The Serial Y-Cable - Overland Storage ARCvault Series Service Manual

Section 4

4.5.3 Reinstalling the Drive Assembly

CAUTION: You MUST connect the BLACK serial cable to the TOP drive and the WHITE serial cable to the
BOTTOM drive for the unit to operate correctly.
1. With the wiring positioned off to the right, slide the drive assembly back into the proper
bay.
2. Attach the serial Y-cable to the rear of the drives
• Attach the black part to the top drive.
• Attach the white part to the bottom drive.
3. Attach the power cables to the drives.
4. Holding the drive cover below the opening, connect the SCSI cable and the fan wiring.
5. Reseat the drive cover and tighten the thumbscrews.
6. Reconnect the SCSI cable and terminator to the drive cover.
7. Plug in the power cord and power on the unit.
8. Check the Status to see if the unit recognizes the new drive.
4–10
Black to Top Drive
White to Bottom Drive

Figure 4-11: Attaching the Serial Y-Cable

(Figure 4-11).
Serial Y-Cable
10400025-101 10/2006
Serial Cable